Different between 3 plate & 2 plate mold making 3 plate mold here is two cavity with 4 pcs pin-point gate, and 2 plate mold is one cavity, offset spruce mold and edge gate. Product Details: Product name: X61A1846 Industries: Industrial Mold Standard: HASCO Steel: S136 HRC 50-54 Cavities 1 x…
offset spruce mold making
Offset spruce mold making is usual for 1 cavity single mold, when it is edge gate not direct gate with submerge. Product Details: Product name: X61A1846 Industries: Industrial Mold Standard: HASCO Steel: NAK 80 HRC 38-42 Cavities 1 x 1 Plastic: PA6+30%GF Runner system: Cold Cycle time: 55s Gate: edge Mold…
slider change part line
Slider change part line Slider solution is most use for mold release, it could be used to change part line too, in order to get better look and better assembly. 1.Part and Part line 2.Part and Part line
what is kiss off & shut off?
What is kiss off & shut off? Some guys are confusion for kiss off & shut off in mold making. The key is to see core and cavity, it will be kiss off if they kiss each other(Mouth to mouth), and it will be shut off if they brush past(Side…
12 cavity family mold making
12 cavity family mold making Family mold is popular in plastic injection mold making, it is usually for small parts, any quantity parts make in one mold is OK. It usually makes mold for toys or other not precision parts. 1. Part Drawing 2. Mold structure 3. Molded parts 4.…
MUD mold making
MUD(Master Unit Die) Mold Design MUD mold is a standardized general mold structure, usually small products, mold parts are common, only replace the mold core part, simple structure, low cost, also known as fast die change. 1. Part Drawing 2. Mold structure 3. Molded parts 4. Mud mold making
ejector pin on slider-CAMS
Ejector pin on slider/CAMS for mold making This is project is very reference value, as there are ejector pin on slider-CAMS, Cooling on slider, Tunnel Slider on slider.